Common problems that occur in the work of semi-automatic round bottle labeling machine

According to the staff of Chunlei Intelligent in the process of debugging the semi-automatic round bottle labeling machine, there are several common problems that occur in the use of the semi-automatic round bottle labeling machine. If these common problems are not handled properly, it will affect the daily operation efficiency. Therefore, the editor of Chunlei Intelligent summarizes several common problems and their solutions for everyone as follows:

1. Unstable labeling position:

- The belt pressing device may not be pressed tightly, resulting in loose label belt and inaccurate electric eye detection. The label needs to be pressed tightly.

- The traction mechanism may slip or not be pressed tightly, resulting in the failure to smoothly take away the bottom paper. The traction mechanism needs to be pressed tightly, but it should also be careful not to tighten it too much to avoid pulling the label crooked.

- The objects to be labeled are of different shapes or inconsistent positioning. Product quality needs to be controlled.

- The objects to be labeled should be placed parallel to the label output direction, and pay attention to whether the product moves during the labeling process.

- The objects to be labeled should ensure smooth rotation at the labeling station to avoid hitting the peeling plate.

2. Label belt deviation:

- The belt pressing device is too tight, causing the label belt to deviate. The pressure on the belt needs to be reduced.

- The belt is not corrected before automatic operation. Correction needs to be performed again.

3. The labeling quality is poor, with bubbles or wrinkles:

- The label is not completely covered, you can try to reduce the speed of labeling.

- The label is too soft or transparent, and the labeling force needs to be adjusted.

- The label is bent when it is extended, and the position of the peeling plate needs to be raised as close to the product as possible.

- The front and back of the label are not aligned, and the inclination of the support rod needs to be adjusted so that the product can be perpendicular to the extension direction of the label.

4. The device does not respond:

- Confirm that there is no problem with the power cord.

- Confirm whether the fuse is intact. If it is burned out, please replace it.

- The internal wiring of the electrical box may be loose, and it is necessary to ask a professional to repair it.

5. The label backing paper often breaks:

- The belt pressing device is too tight, causing the label to deviate. The pressure on the belt needs to be reduced.

- The label backing paper is of poor quality or the cut is too deep. Qualified labels need to be replaced.

- The label feeding speed is too fast. The speed needs to be reduced.

- Pay attention to whether the label is scratched during the movement.

6. Continuous labeling and uncontrolled label stop:

- The detection electric eye is not set properly and needs to be reset.

- The electric eye is not suitable for the detected label and needs to be replaced with a suitable electric eye.

- The electric eye is damaged and needs to be replaced.

- It takes several steps on the foot switch to complete a labeling. It may be that the electric eye signal of the sensing label is interfered and the electric eye needs to be reset.

The above are some common problems and solutions of the semi-automatic round bottle labeling machine edited by Chunlei Intelligent Editor for everyone. I hope it will be helpful to you. In the process of using the semi-automatic round bottle labeling machine, you should pay attention to the occurrence of these problems to avoid affecting work efficiency. If there are other more serious problems, please contact professional technicians for technical guidance.